1281
undo default-cost
View OSPFv3 area view
Parameters value: Specifies a cost for the default route advertised to the stub area, in the
range of 0 to 65535. The default is 1.
Description Use the
default-cost command to specify the cost of the default route to be
advertised to the stub area.
Use the
undo-default-cost command to restore the default value.
Use of this command is only available on the ABR that is connected to a stub area.
You have two commands to configure a stub area: stub, defaulted-cost. You
need to use the stub command on routers connected to a stub area to configure
the area as stub.
If multiple OSPFv3 processes are running, use of this command takes effect only
for the current process.
Related commands: stub(OSPFv3 area view).
Examples # Configure Area1 as a stub area, and specify the cost of the default route
advertised to the stub area as 60.
<Sysname> system-view
[Sysname] ospfv3
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] stub
[Sysname-ospfv3-1-area-0.0.0.1] default-cost 60
display debugging ospfv3
Syntax display debugging ospfv3
View Any view
Parameters None
Description Use the
display debugging ospfv3 command to display global OSPFv3
debugging state information.
Examples # Display the global OSPFv3 debugging state information.
<Sysname> display debugging ospfv3
OSPFv3 External route calculation debugging is on
