2542 CHAPTER 172: IPX CONFIGURATION COMMANDS
Use the undo ipx rip multiplier command to restore the default.
The default is 3 times the update interval.
A timer is set for each routing entry to keep track of elapsed time since the route
was received. Every time the updating packet containing the route is received, the
timer is reset to zero. If a RIP route is not updated within the aging period, the
system will regard the route as invalid and will delete it from the routing table.
Related command: ipx rip timer update.
Example # Configure the aging interval to be 5 times the update interval.
<Sysname> system-view
[Sysname] ipx rip multiplier 5
ipx rip timer update
Syntax ipx rip timer update seconds
undo ipx rip timer update
View System view
Parameter seconds: RIP updating interval in seconds, ranging from 10 to 60,000.
Description Use the
ipx rip timer update command to specify a RIP update interval.
Use the
undo ipx rip timer update command to restore the default.
The default update interval is 60 seconds.
Related command: ipx rip multiplier.
Example # Specify a RIP update interval of 30 seconds.
<Sysname> system-view
[Sysname] ipx rip timer update 30
ipx route-static
Syntax ipx route-static dest-network { network.node | interface-type interface-number }
[ preference value ] [ tick ticks hop hops ]
undo ipx route-static {dest-network [ nexthop-addr | interface-type
interface-number ] | all }
View System view
