408 CHAPTER 22: FRAME RELAY CONFIGURATION COMMANDS
Example # Clear all the frame relay dynamic address maps.
<Sysname> reset fr inarp
reset fr pvc
Syntax reset fr pvc interface serial interface-number [ dlci dlci-number ]
View User view
Parameter interface-number: Interface number.
dlci dlci-number: DLCI assigned to an FR interface. The dlci-number argument is in
the range 16 to 1007. Note that DLCI 0 through 15 and 1008 through 1023 are
reserved for special use and are thus unavailable.
Description Use the
reset fr pvc command to clear the statistics on a PVC.
Example # Clear PVC statistics on Serial 2/0.
<Sysname> reset fr pvc interface serial 2/0
timer hold
Syntax timer hold seconds
undo timer hold
View Interface view
Parameter seconds: Value of T391 parameter at DTE side, which ranges from 0 to 32767 in
seconds. 0 indicates that the LMI protocol is disabled.
Description Use the
timer hold command to configure T391 parameter at the DTE side.
Use the undo timer hold command to restore the default.
By default, the parameter is 10 seconds.
The parameter is a time variable that defines the interval of Status-Enquiry packet
sent by DTE.
Related command: fr lmi t392dce.
Example # Configure that frame relay interface Serial 2/0 to operate in DTE mode, and set
the value of T391 parameter to 15 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
