559
broadcast: Specifies to allow bridging of broadcasts over this FR-to-bridging
mapping.
Description Use the fr map bridge command to create an FR-to-bridging mapping on the
specified virtual circuit.
Use the
undo fr map bridge command to remove an FR-to-bridging mapping.
By default, no FR-to-bridging mappings exist.
Related command: display fr map-info on page 376.
Example # Create an FR-to-bridging mapping on the virtual circuit by the DLCI of 50 on
Serial2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr interface-type dce
[Sysname-Serial2/0] fr dlci 50
[Sysname-Serial2/0] bridge-set 1
[Sysname-Serial2/0] fr map bridge 50 broadcast
interface bridge-template
Syntax interface bridge-template bridge-set
undo interface bridge-template bridge-set
View System view
Parameters bridge-set: Bridge set number, an integer in the range of 1 to 255.
Description Use the
interface bridge-template command to create a bridge-template
interface for a bridge set.
Use the
undo interface bridge-template command to remove a
bridge-template interface.
A bridge set can have only one bridge-template interface.
Related command: bridge routing-enable.
Example # Create a bridge-template interface for bridge set 1.
<Sysname> system-view
[Sysname] interface bridge-template 1
[Sysname-Bridge-template1]
