1495
register-whole-checksum (IPv6 PIM view)
Syntax register-whole-checksum
undo register-whole-checksum
View IPv6 PIM view
Parameter None
Description Use the
register-whole-checksum command to configure the router to
calculate the checksum based on the entire register message.
Use the
undo register-whole-checksum command to restore the default
configuration.
By default, the checksum is calculated based only on the header in the register
message.
Related command: register-policy (IPv6 PIM view) and register-suppression-timeout (IPv6 PIM
view).
Example # Configure the router to calculate the checksum based on the entire register
message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-whole-checksum
reset pim ipv6 control-message counters
Syntax reset pim ipv6 control-message counters [ interface interface-type
interface-number ]
View User view
Parameter interface-type interface-number: Specifies to reset the IPv6 PIM control message
counter on a particular interface. If no interface is specified, this command will
clear the statistics information about IPv6 PIM control messages on all interfaces.
Description Use the
reset pim ipv6 control-message counters command to reset IPv6
PIM control message counters.
Example # Reset IPv6 PIM control message counters on all interfaces.
<Sysname> reset pim ipv6 control-message counters
