2649
By default, the originating party requires the terminating party to send answer
signal.
This command applies to R2 signaling only.
The R2 line signaling coding schemes in some countries do not include answer
signal sending. To accommodate to such schemes, you must configure the
answer enable command on the originating point. This allows the terminating
point to set up calls after a specified time period.
Related command: re-answer enable and timer dl re-answer.
Example # Configure the originating point to disable the terminating point from sending
answer signals.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] undo answer enable
callmode
Syntax callmode { segment | terminal }
undo callmode
View R2 CAS view
Parameter segment: Specifies the connection mode for an R2 call as segment-to-segment.
terminal: Specifies the connection mode for an R2 call as terminal-to-terminal.
Description Use the
callmode command to configure the connection mode for an R2 call.
Use the
undo callmode command to restore the default setting.
By default, the connection mode for an R2 call is terminal.
Example # Set the connection mode for an R2 call to segment.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas 1/0:0] callmode segment
cas
Syntax cas ts-set-number
