168 CHAPTER 8: GENERAL ETHERNET INTERFACE CONFIGURATION COMMANDS
duplex
Syntax duplex { auto | full | half }
undo duplex
View Ethernet interface view
Parameter auto: Indicates that the interface is in an auto-negotiation state.
full: Indicates that the interface is in a full-duplex state.
half: Indicates that the interface is in a half-duplex state.
Description Use the
duplex command to configure the duplex mode for an Ethernet
interface.
Use the
undo duplex command to restore the duplex mode for an Ethernet
interface to the default.
By default, the duplex mode for an Ethernet interface is auto.
Related command: speed.
Example # Configure the interface Ethernet 1/0 to work in full-duplex mode.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] duplex full
flow-control
Syntax flow-control
undo flow-control
View Ethernet interface view
Input (total):
Input (normal):
Input:
Output (total):
Output (normal):
Output:
Error statistics on the interface inbound and
outbound packets, underscore indicates that the
corresponding entry is invalid
Table 12 Description on the fields of the display interface command (in bridge mode)
Field Description
