466 CHAPTER 26: LAPB AND X.25 CONFIGURATION COMMANDS
Example # Set the restart timer on the X.25 interface Serial 2/0 to 120 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx0 120
x25 timer tx1
Syntax x25 timer tx1 seconds
undo x25 timer tx1
View Interface view
Parameter seconds: Time of calling request (indication) sending timer in seconds, ranging
from 0 to 1000.
Description Use the
x25 timer tx1 command to set calling request (indication) sending timer
for the DTE (or DCE).
Use the
undo x25 timer tx1 command to restore the default.
By default, the timer time on a DTE is 200 seconds, and that on a DCE is 180
seconds.
According to X.25, a timer should be started when the DTE sends a call request (or
the DCE sends a call indication). If no peer acknowledgement is received after the
timer timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the time of this timer.
Related command: x25 timer tx0, x25 timer tx2, x25 timer tx3.
Example # Set calling request (indication) sending timer on the X.25 interface Serial2/0 to
100 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx1 100
x25 timer tx2
Syntax x25 timer tx2 seconds
undo x25 timer tx2
View Interface view
Parameter seconds: Reset request (indication) timer in seconds, ranging from 1 to 1000.
