1490 CHAPTER 93: IPV6 PIM CONFIGURATION COMMANDS
Parameter None
Description Use the
pim ipv6 require-genid command enable rejection of hello messages
without Generation_ID.
Use the
undo pim ipv6 require-genid command to restore the default
configuration.
By default, hello messages without Generation_ID are accepted.
Example # Enable Ethernet 1/0 to reject hello messages without Generation_ID.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] pim ipv6 require-genid
pim ipv6 sm
Syntax pim ipv6 sm
undo pim ipv6 sm
View Interface view
Parameter None
Description Use the
pim ipv6 sm command to enable IPv6 PIM-SM.
Use the undo pim ipv6 sm command to disable IPv6 PIM-SM.
By default, IPv6 PIM-SM is disabled.
Related command: pim ipv6 dm.
Example # Enable IPv6 PIM-SM on Ethernet 1/0.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] pim ipv6 sm
pim ipv6 state-refresh-capable
Syntax pim ipv6 state-refresh-capable
undo pim ipv6 state-refresh-capable
View Interface view
Parameter None
