1185
validate-source-address
Syntax validate-source-address
undo validate-source-address
View RIP view
Parameters None
Description Use the
validate-source-address command to enable the source IP address
validation on incoming RIP routing updates.
Use the
undo validate-source-address command to disable the source IP
address validation.
The source IP address validation is enabled by default.
Generally, disabling the validation is not recommended.
Examples # Enable the source IP address validation on incoming messages.
<Sysname> system-view
[Sysname-rip] rip 100
[Sysname-rip-100] validate-source-address
version
Syntax version { 1 | 2 }
undo version
View RIP view
Parameters 1: Specifies the RIP version as RIP-1.
2: Specifies the RIP version as RIP-2. RIP-2 messages are multicast.
Description Use the
version command to specify a global RIP version.
Use the undo version command to remove the configured global RIP version.
By default, the global RIP version is RIP-1.
Note that:
■ If an interface has an RIP version specified, the RIP version takes precedence
over the global one.
