1303
Related commands: ospfv3 timer dead.
Examples # Configure the hello interval as 20 seconds for an interface of instance 1.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ospfv3 timer hello 20 instance 1
ospfv3 timer retransmit
Syntax ospfv3 timer retransmit interval [ instance instance-id ]
undo ospfv3 timer retransmit [ instance instance-id ]
View Interface view
Parameters interval: Specifies LSA retransmission interval in seconds for an interface, ranging
from 1 to 65535.
instance-id: The instance ID of an interface, in the range of 0 to 255, which
defaults to 0.
Description Use the
ospfv3 timer retransmit command to configure the LSA
retransmission interval for an interface of an instance.
Use the
undo ospfv3 timer retransmit command to restore the default.
The interval defaults to 5 seconds.
When a router sends a LSA to its neighbor, it waits for an acknowledgement. If
receiving no acknowledgement after retransmission interval elapses, it will
retransmit the LSA.
The LSA retransmission interval should not be too small for avoidance of
unnecessary retransmissions.
Examples # Configure the LSA retransmission interval on an interface of instance 1 as 12
seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] ospfv3 timer retransmit 12 instance 1
ospfv3 trans-delay
Syntax ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ instance instance-id ]
View Interface view
