133
display dsl status
Syntax display dsl status interface atm interface-number
View Any view
Parameter interface-number: Specifies a G.SHDSL interface to view the status information
about.
Description Use the
display dsl status command to display status information about the
specified G.SHDSL interface.
Example # Display status information about ATM 5/0, which is a two-wire G.SHDSL
interface that is up.
<Sysname> display dsl status interface atm 5/0
Operating Mode: CPE
DSL Mode: SHDSL Annex B
Configured Wire Type: 2
Line A Statistics since last activation:
CRC: 0
LOSW Defect: 0
ES: 0
SES: 0
UAS: 0
TX EOC: 0
RX EOC: 0
Line A status:
Xcvr Op State: Data Mode
Last Fail Op State: 0x00
Frame Sync: in sync
Line Rate(Kbps): 2312
Wire Type: 2
SNR Margin(dB): 16.30
Loop Attenuation(dB): 0.00
RecvGain(dB): 6.07
TxPower(dBm): 9.50
Power Backoff: enable
Power Backoff Level: 5
Tip/Ring Reversal: Reversed
FrmOH Stat: 0x00
Rmt EncoderA:0x0000016e
Target Margin Target margin
Line Rate Line rate
PSD Mode Power spectral density mode: symmetric or asymmetric
Power-Backoff Power compensation
LinkCheck State of link check: enable or disable
Actual Handshake Status --
Local Handshake Status --
Remote Handshake Status --
Table 1 Description on the fields of the display dsl configuration command
Field Description
