2524 CHAPTER 170: ACSEI CLIENT CONFIGURATION COMMANDS
Description Use the acsei-client debug enable command to enable debugging for ACSEI
client.
By default, debugging for ACSEI client is disabled.
Examples # Enable debugging for ACSEI client.
<Sysname> oap connect slot 6
Connected to OAP!
[root@localhost ~]# acsei-client debug enable
acsei-client debug show
Syntax acsei-client debug show
View Any directory of the Linux system
Parameters None
Description Use the
acsei-client debug show command to display the debugging
information about ACSEI client.
By default, no ACSEI client debugging will be displayed.
ACSEI client debugging is displayed through a pipe; therefore, part of the
debugging information may fail to be displayed when the pipe is full.
Examples # Display the ACSEI client debugging information.
<Sysname> oap connect slot 6
Connected to OAP!
[root@localhost ~]# acsei-client debug enable
[root@localhost ~]# acsei-client debug show
chkconfig acseid off
Syntax chkconfig acseid off
View Any directory of the Linux system
Parameters None
Description Use the
chkconfig acseid off command to configure not to start up ACSEI client
automatically, that is, configure not to start up ACSEI client simultaneously with
the system.
By default, ACSEI client installed on the OAP module is started up automatically
when the system is started up.
