Filter
Top Products
Rev. 5.00, 09/03, page 510 of 760
Retransmission when SCI is in Transmit Mode: Figure 15.10 shows the retransmission
operation in the SCI transmit mode.
1. After transmission of one frame is completed, the FER/ERS bit in SCSSR is set to 1 when a
error signal is returned from the receiving side. If the RIE bit in SCSCR is enabled at this time,
an ERI interrupt is requested. Be sure to clear the FER/ERS bit before the next parity bit is
sampled.
2. The TEND bit in SCSSR is not set in the frame that received the error signal indicating the
error.
3. The FER/ERS bit in SCSSR is not set when no error signal is returned from the receiving side.
4. When no error signal is returned from the receiving side, the TEND bit in SCSSR is set to 1
when the transmission of the frame that includes the retransmission is considered completed. If
the TIE bit in SCSCR is enabled at this time, a TXI interrupt will be requested.
D0Ds D2D1 D4D3 D6D5 Dp DED7 D0Ds D2D1 D4D3 D6D5 Dp
(DE)
D7 D0Ds D2D1 D4D3
nth transfer frame
TEND
FER/ERS
Transfer from SCTDR
to SCTSR
Transfer from SCTDR
to SCTSR
Transfer from SCTDR
to SCTSR
1
2 4
3
Retransmitted frame Transfer frame n + 1
TDRE
Figure 15.10 Retransmission in SCI Transmit Mode