Filter
Top Products
Rev. 5.00, 09/03, page 216 of 760
Bit 6—Timer Mode Select (WT/I
II
IT
TT
T): Selects whether to use the WDT as a watchdog timer or an
interval timer.
Bit 6: WT/I
II
IT
TT
T Description
0 Used as interval timer (Initial value)
1 Used as watchdog timer
Note: If WT/IT is modified when the WDT is running, the up-count may not be performed correctly.
Bit 5—Reset Select (RSTS): Selects the type of reset when WTCNT overflows in watchdog
timer mode. In interval timer mode, this setting is ignored.
Bit 5: RSTS Description
0 Power-on reset (Initial value)
1 Manual reset
Note: RESETOUT is output.
Bit 4—Watchdog Timer Overflow (WOVF): Indicates that the WTCNT has overflowed in
watchdog timer mode. This bit is not set in interval timer mode.
Bit 4: WOVF Description
0 No overflow (Initial value)
1 WTCNT has overflowed in watchdog timer mode
Bit 3—Interval Timer Overflow (IOVF): Indicates that WTCNT has overflowed in interval
timer mode. This bit is not set in watchdog timer mode.
Bit 3: IOVF Description
0 No overflow (Initial value)
1 WTCNT has overflowed in interval timer mode
Bits 2 to 0—Clock Select 2 to 0 (CKS2 to CKS0): These bits select the clock to be used for the
WTCNT count from the eight types obtainable by dividing the peripheral clock. The overflow
period in the table is the value when the peripheral clock (Pφ) is 15 MHz.