Filter
Top Products
Rev. 5.0, 09/03, page xii of xliv
Section Page Description
10.2.13 MCS0 Control
Register (MCSCR0)
258
Description added
Bit 6—CS2/CS0 Select (CS2/0)
Only 0 should be used for the CS2/0 bit in MCSCR0. Either 0 or 1
may be used for MCSCR1 to MCSCR7.
10.3.4 Synchronous
DRAM Interface
290
Bank Active description added
… .In bank active mode, too, all banks become inactive after a
refresh cycle or after the bus is released as the result of bus
arbitration.
The bank active mode should not be used unless the bus width
for all areas is 32 bits.
10.3.6 PCMCIA
Interface
Figure 10.32 Basic
Timing for PCMCIA
Memory Card Interface
310
Figure amended
D15 to D0
(
Write)
10.3.7 Waits between
Access Cycles
Figure 10.40 Waits
between Access Cycles
320
Figure amended
T
1
CKIO
A
25 to A0
T
2
Twait T
1
T
2
Twait T
1
T
2
10.3.10 MCS[0] to
MCS[7] Pin Control
323
Description amended
This enables 32-, 64-, 128-, or 256-Mbit memory to be connected
to area 0 or area 2.
However, only CS2/0 = 0 (area 0) should be
used for MCSCR0. Table 10.15 shows MCSCR0–MCSCR7
settings and MCS[0]–MCS[7] assertion conditions.
11.6 Usage Notes
387
Description added
13. DMAC transfers should not be performed in the sleep mode
under conditions other than when the clock ratio of Iφ (on-
chip clock) to Bφ (bus clock) is 1:1.
14. When the following three conditions are all met, the
frequency control register (FRQCR) should not be changed
while a DMAC transfer is in progress.
• Bits IFC2 to IFC0 are changed.
• STC2 to STC0 in FRQCR are not changed.
• The clock ratio of Iφ (on-chip clock) to Bφ (bus clock) after
the change is other than 1:1.
13.4.3 Precautions
when Using RTC
Module Standby
426
Newly added