Filter
Top Products
Rev. 5.00, 09/03, page 93 of 760
4.4 Exception Handling Operation
4.4.1 Reset
The reset sequence is used to power up or restart the SH7709S from the initialization state. The
RESETP and RESETM signals are sampled every clock cycle, and in the case of a power-on reset,
all processing being executed (excluding the RTC) is suspended, all unfinished events are
canceled, and reset processing is executed immediately. In the case of a manual reset, however,
reset processing is executed after completion of any memory access being executed. The reset
sequence consists of the following operations:
1. The MD bit in SR is set to 1 to place the SH7709S in privileged mode.
2. The BL bit in SR is set to 1, masking any subsequent exceptions (except the NMI interrupt
when the BLMSK bit is 1).
3. The RB bit in SR is set to 1.
4. An encoded value of H'000 in a power-on reset or H'020 in a manual reset is written to bits 11–
0 of the EXPEVT register to identify the exception event.
5. Instruction execution jumps to the user-written exception handler at address H'A0000000.
4.4.2 Interrupts
An interrupt handling request is accepted on completion of the current instruction. The interrupt
acceptance sequence consists of the following operations:
1. The contents of PC and SR are saved to SPC and SSR, respectively.
2. The BL bit in SR is set to 1, masking any subsequent exceptions (except the NMI interrupt
when the BLMSK bit is 1).
3. The MD bit in SR is set to 1 to place the SH7709S in privileged mode.
4. The RB bit in SR is set to 1.
5. An encoded value identifying the exception event is written to bits 11–0 of the INTEVT and
INTEVT2 registers.
6. Instruction execution jumps to the vector location designated by the sum of the value of the
contents of the vector base register (VBR) and H'00000600 to invoke the exception handler.