Filter
Top Products
Rev. 5.0, 09/03, page xiii of xliv
Section Page Description
16.4 SCIF Interrupts
550
Description amended
When the TDFE flag in the serial status register (SCSSR) is set to
1, a TXI interrupt request is generated. The DMAC can be
activated and data transfer performed when this interrupt is
generated.
When data exceeding the transmit trigger number is
written to the transmit data register (SCFTDR) by the DMAC, 1 is
read from the TDFE flag, after which 0 is written to it to clear it.
When the RDF flag in SCSSR is set to 1, an RXI interrupt request
is generated. The DMAC can be activated and data transfer
performed when the RDF flag in SCSSR is set to 1. When
receive data less than the receive trigger number is read from the
receive data register (SCFRDR) by the DMAC, 1 is read from the
RDF flag, after which 0 is written to it to clear it.
Description amended
1. SCFTDR Writing and TDFE Flag:
However, if the number of data bytes written to SCFTDR is equal
to or less than the transmit trigger number,
the TDFE flag will be
set to 1 again even after having been cleared to 0. TDFE clearing
should therefore be carried out after data exceeding the specified
transmit trigger number has been written to SCFTDR.
16.5 Usage Notes
551
2. SCFRDR Reading and RDF Flag:
However, if the number of data bytes in SCFRDR exceeds the
trigger number, the RDF flag will be set to 1 again even after
having been cleared to 0. RDF should therefore be cleared to 0
after being read as 1 after all the receive data has been read.
19.13.2 SC Port Data
Register (SCPDR)
610
Title Amended