Operating Information
2–12
AM700 Audio Measurement Set Service Manual
another application is started prior to power off. State Save does not return the
application that was running at power off when power is again turned on, but the
user selections for an application that were saved will be restored.
Also, refer to the Save AM700 State function discussion in the AM700 Audio
Measurement Set User Manual. The Save AM700 State function generates new
functions that store customized application setups. These application setup
functions are then used in making repetitive tests and for building a standardized
set of application setups that can be transferred to other AM700 Audio Measure-
ment Sets.
Figure 2–10: System status display
From the Configure screen, first select Input Selection. In here are the choices
you need to make for input connector selection for the digital and analog signals,
the input impedance and gain range of the analog inputs, and the signal
selections to apply to the two measurement channels of the AM700. Alternately,
you may wish to select a Quick Setup. In the Quick Setup choices you will find
setup templates for often-used measurements. Those are given in the Quick Setup
discussion at the end of this section.
The Input Selection block diagram shown in Figure 2–11 graphically shows the
input section of the AM700. Touch screen selections allow the user to choose a
wide variety of signal sources and paths.
Input Selection