Filter
Top Products
Operating Information
AM700 Audio Measurement Set Service Manual
2–21
The System Setup menu is used to set the system clock, the serial and GPIB
communication parameters, the hard copy output format, run the AM700
calibration routine, and set the input, output, and dBFS conversion factors.
System Copy. The control screen display for setting the Copy parameters is
reached either through the Configure System Setup menu or directly by pressing
and holding the Copy front-panel button to bring up the same menu. Press and
hold the Copy button to display the Copy Configuration screen see Figure 2–17.
NOTE. Pressing and holding the Copy button immediately brings up the
Configure menu, with the System Setup choices for Copy displayed. This is the
same screen that is displayed by pressing the Configure button, then System
Setup.
In this screen you may set the following copy functions:
H copy output format
H copy destination
H file name when File is the selected copy destination
Figure 2–17: The copy configuration menu
System Setup Menu