Tektronix AM700 Stereo System User Manual


 
Operating Information
AM700 Audio Measurement Set Service Manual
2–17
View Types. The View Types column in the figure shows the icons for these view
types. Each view may be a different view type. Selecting a particular view type
of a view is done by first selecting the view you wish to change in the View
Selection bar. Only the selected view is affected by a change in the choices. The
Measurement column shows the measurement types that are available for
viewing in a view window. Altering those choices is done in the Measurements
Setup menu that will be discussed later.
You may set up a view to display FFT measurements or Multitone measurements
but not both. The View Types that are available also depend on the measurement
selected as they are different for FFT and Multitone. The applicable choices will
be displayed for the Measurement Type selected for a view. Notice that both FFT
traces may be displayed in the same view window.
View Options. The View Options menu permit selection of axis types, display
persistence, and cursor actions as shown in Figure 2–14. When selected by
touching the enable soft key, a check mark appears in the soft key to show that it
is enabled. Touch the enable soft key again to remove the check mark and return
to the alternate choice.
Figure 2–14: FFT Analyzer view options in the view setup controls