Filter
Top Products
Performance Verification
AM700 Audio Measurement Set Service Manual
4–57
--- FLOPPY DIAGNOSTIC ---
Configure CUSTOM RUN MODE parameters and the test
Key Selection
____________________________________
S ... -Sequence- Type (CUSTOM)
1 ... Advance Mode (MANUAL)
2 ... Result Display Mode (SHOW ALL)
____________________________________
= ... Reprint @ ... Abort Menu
____________________________________
Input your selection:
3 ... Result Logging Mode (DISABLED)
B ... -BUILD- New Test Sequence
sequence as desired.
Figure 4–24: Low level diagnostic OVERALL RUN MODE menu
6. Select “B” Build a New Test Sequence and press the Select button to display
the floppy drive test choices available in the diagnostic as shown in
Figure 4–25.
Low Level Diagnostic Interface
--- Floppy Diagnostic ---
Build a new CUSTOM TEST SEQUENCE by selecting test from
Key Selects/Unselects
__________________________________
A ... UI: Disk Status Query
B ... UI: Disk Format
C ... UI: Drive Stress Test
= ... Reprint @ ... Abort Menu
__________________________________
Selection(s): *** NONE ***
__________________________________
+ ... Select All - ... Un-Sel All
! ... Done Selecting
those listed. (Tests prefaced with "UI:" require USER
INTERACTION)
Figure 4–25: Build CUSTOM TEST SEQUENCE menu for disk drive test