Filter
Top Products
Operating Information
2–8
AM700 Audio Measurement Set Service Manual
2. Touch the System Setup selection to display the setup menu choices. Setting
the clock is the default selection, and the clock face appears as seen in
Figure 2–6.
3. Check the date and time settings. If any are not correct, they may be selected
and adjusted to the correct setting. A selected choice changes intensity to
show that editing of that setting is active.
Figure 2–6: AM700 Audio Measurement Set system clock
4. Setting may be done by rotating the large control knob or by making a direct
keypad entry of the new value and pressing the Enter button. Changes made
to the time are shown in the clock as they are entered, but those changes are
not permanent until the Accept Changes soft key is touched.
5. When the date and time are correct, touch the Accept Changes soft key. This
changes the time to the new values and returns to the previous application.