Filter
Top Products
Rack Adapter Instructions
AM700 Audio Measurement Set Service Manual
6–99
Figure 6–52: Removing the thumb release button from the swing arm
CAUTION. Do not reinsert the swing handle screws in the cabinet screw holes;
they are too long and will damage internal components.
8. Using a TorxR screwdriver with T15 bit, remove the screws and washers, as
shown in Figure 6–53, that hold both swing arms to the cabinet of the
measurement set.
9. Insert the blade of the 1/16 inch screwdriver about 3/4 inch into the center
screw hole of the plastic holder for the star sprocket. Pry gently forward and
then backward to detach the holder from the cabinet. Repeat for the other
side.
10. Put the screws, handle, and other hardware away for safekeeping for possible
future reassembling. The removed screws will not be used in mounting the
measurement set to the adapter.