Tektronix AM700 Stereo System User Manual


 
Performance Verification
AM700 Audio Measurement Set Service Manual
4–55
3. Touch Drive on the right side of the Storage Manager screen to select the
nvram:.directory.
4. On the right side of the Storage Manager screen select the function directory.
This done by first touching the directory name to shift the knob focus to that
side. Once the focus is shifted, you can use the large knob to make further
selections by scrolling through the list.
5. With the function/directory highlighted, touch the Change Directory soft key
to go into that directory. You will then see a list of files if any are stored
there.
6. Touch a file name in the function files display area to make sure the knob
focus is on the right side, and use the large control knob to select a file to be
transferred to the disk.
7. Touch Drive on the left side of the Storage Manager to select dos: A list of
the directories and files at the top level of the disk directory will be
displayed.
8. Touch Copy to copy the file from nvram:/function to dos.
9. Check that the name of the file you copied appears in the dos: directory.
10. Touch the file name in the dos: directory file list.
11. Touch the Delete soft key. You will get a notifier asking if you really want to
delete the selected file. Touch OK to delete the file. Check that the file is
deleted from the dos: directory.
A more intensive check of the disk drive can be done using the low level
diagnostics function when the AM700 has V1.02 or above firmware installed.
Use the following procedure to perform the disk drive stress test.
1. Turn the AM700 off.
2. Hold in the Menu button and turn the AM700 back on.
3. When the AM700 beeps twice, the low-level diagnostic start up mode has
been recognized. Release the Menu button.
Alternate Disk Drive
Verification V1.02
Firmware