Filter
Top Products
Removal and Replacement Procedures
AM700 Audio Measurement Set Service Manual
6–77
Cable retaining
bracket
Figure 6–38: Trim ring and LCD flat panel display retaining screws
6. Pull the Front Panel assembly out far enough to disconnect the ribbon cable
connector, J1, on the bottom of the assembly; the flexible circuit board
connector, J4, on the left side of the circuit board (looking from the front);
and the headphone cable, at J6.
7. Use a T-15 Torx tip to remove the two screws holding the display driver
cable retaining bracket, and remove the bracket from the chassis.
NOTE. With the cabinet is removed, disconnecting the ribbon cable to the front
panel from the CPU board at J50 permits easier removal of the Front Panel
assembly.
8. Remove the screws holding the LCD assembly to to the front casting (four
screws holding the touch screen and four screws holding the LCD assembly
rear shield).