Tektronix AM700 Stereo System User Manual


 
Rack Adapter Instructions
AM700 Audio Measurement Set Service Manual
6–101
Removing the Measurement Set from the Rack
The rackmounted measurement set and adapter may be easily removed from the
rack. The slide-out tracks permit the rack-adapted AM700 to be extended out of
the rack for access to the rear-panel connectors. Before attempting to operate the
instrument in the extended position, be sure the power cord and any other
connected cabling is long enough to permit full extension.
1. Loosen the front-panel thumb screw that secures the rackmounted measure-
ment set into the rack.
2. Extend the tracks to the stops and disconnect all the rear-panel cabling from
the measuerment set.
3. Press both stop latch releases and pull the adapter out of the slide tracks. The
procedure is illustrated in Figure 6–54.
TO INSTALL:
1. Pull the slide-out track section to the
fully extended position.
2. Insert the instrument chassis sections
into the slide-out sections.
3. Press the stop latches and push the
instrument toward the rack until the
latches snap into their holes.
4. Again press the stop latches and push
the instrument fully into the rack.
5. Tighten the front-panel thumb screw.
TO REMOVE:
1. Loosen retaining screw and pull
instrument outward until the stop latches
snap into the holes.
2. Disconnect the rear-panel cables.
3. Press stop latches and remove
instrument.
Figure 6–54: Installing and removing the AM700 Audio Measurement Set from the
rack