Filter
Top Products
Performance Verification
4–58
AM700 Audio Measurement Set Service Manual
7. Select “C” Drive Stress Test and press the Select button.
8. After you have made the test selections you want in the custom list,
highlight the ! (Done Selecting) and press Select. This returns to the next
higher level menu where the choice to run the tests in the custom list you
have just made becomes available.
9. Select “R” Run Test Sequence and press the Select button to begin the drive
stress test. You have to insert a MS DOS formatted 1.4 Meg diskette into the
AM700 disk drive to do this test.
The drive stress test take some time to do as it writes to the 80 tracks and verifies
the test. The track being written is indicated in the display. When the testing is
complete, the test results are displayed. A passing test result is shown in
Figure 4–26.
Drive Stress Test
Track Write ĆĆĆĆ
Test measmt unit min max result
Track Read ĆĆĆĆĆ
0 errors ĆĆĆĆĆĆ 0 - Pass -
0 errors ĆĆĆĆĆĆ 0 - Pass -
Track Seek ĆĆĆĆĆ
0 errors ĆĆĆĆĆĆ 0 - Pass -
0 errors ĆĆĆĆĆĆ 0 - Pass -
Data Verify ĆĆĆ
======================================================
==>> CURRENT TEST SEQUENCE COMPLETED <<==
==>> Press any key to Continue <<==
Floppy Diagnostic
Figure 4–26: Floppy diagnostic drive stress test results