Filter
Top Products
AM700 Audio Measurement Set Service Manual
6–55
Removal and Replacement Procedures
This section provides a tool list and instructions required to remove modules
within the instrument. All module and board removal procedures assume that the
instrument cover has been removed. All work should be done at an approved
work bench for static-damage prevention.
Posidrive screwdriver, 2X
Crosstip screwdriver, P1
Torx screwdriver, T-15 and T-10
Flat-bit screwdriver, 3/32-inch (filed down for a blunter point and narrower tip)
Nut driver, 1/4-inch and 5/16-inch
Hex wrench, 1/16-inch (for knob removal only)
Needle-nose pliers
Cover Removal and Replacement
1. Install the protective front panel cover on the instrument.
2. Turn off the Power switch on the rear panel and disconnect the AC Mains
power cable.
3. Set the instrument so that the protective front panel cover is sitting on your
work surface.
NOTE. If you do not have the protective front panel cover you may set the
instrument on a cushioned surface. The surface should be stable so that the
instrument does not tip over.
4. On the rear of the instrument you will find a black “foot” in each of the four
corners, remove the screws that secure the feet with a 2X Posidrive
screwdriver.
5. Pull the instrument cover up and off of the instrument.
1. Install the protective front panel cover on the instrument.
2. Check that all cables are lying as flat against the instrument as possible.
3. Set the instrument so that the protective front panel cover is sitting on your
work surface.
Tools Required
Instrument Cover
Removal
Instrument Cover
Replacement