Filter
Top Products
Appendix I-Polycom Open Collaboration Network (POCN)
Polycom, Inc. I-31
i In the Outbound Proxy Servers table, the Port field must be set to 5061. (The same
value as entered in Step g.)
For more information see the Polycom Unified Communications Deployment Guide for
Microsoft Environments.
4 Set the MIN_TIP_COMPATIBILITY_LINE_RATE System Flag.
The MIN_TIP_COMPATIBILITY_LINE_RATE System Flag determines the minimum
line rate at which a Profile can be TIP enabled.
CTS version 1.7 requires a minimum line rate of 1024 kbps and will reject calls at lower
line rates, therefore the System Flag value must be 1024 or higher.
For more information see "Modifying System Flags” on page 22-1.
5 Reset the MCU.
6 For more information see "Resetting the RMX” on page 21-69.
7 Register the DMA to the Lync server
For more information see the Polycom Unified Communications Deployment Guide for
Microsoft Environments, “Configure a DMA System SIP Peer for the Lync Server”.
8 Register the ITP endpoints to the Lync server
For more information see the Polycom Unified Communications Deployment Guide for
Microsoft Environments, “Deployment Process for Polycom Immersive Telepresence Systems”.
9 Register Lync Clients to the Lync server
For more information see the relevant Lync documentation.
10 Register DMA to the CUCUM server
For more information see the Polycom Unified Communications Deployment Guide for Cisco
Environments, “Using a Polycom DMA System in a Cisco Environment”.
11 Register CTS1000
and CTS3000 endpoints to the CUCUM server
For more information see the relevant Cisco documentation.
12 Register ITP endpoints to the CUCM server.