Polycom RMX 1500 Stereo Receiver User Manual


  Open as PDF
of 1010
 
Polycom RealPresence Collaboration Server (RMX) 1500/2000/4000 Administrator’s Guide
I-4 Polycom, Inc.
Polycom Equipment
DMA 7000 4.0 Polycom Distributed Media Application
DMA is an optional component but is essential if Content
sharing is to be enabled.
All SIP endpoints register to DMA as a SIP Proxy.
DMA should be configured to route SIP calls (with CTS
destination) to CUCM. If DMA is not present in the
solution architecture, SIP endpoints must register to
CUCM as gatekeeper.
DMA must be configured with a VMR (Virtual Meeting
Room). Incoming calls are then routed to the MCU.
MCU 7.6 and
higher
MCU:
Functions as the network bridge for multipoint calls
between H.323, SIP and TIP endpoints.
The MCU can be interfaced to CUCM using a SIP trunk,
enabling CTS to join multipoint calls on MCU. Signaling
goes through the CUCM while the media in TIP format
goes directly between the CTS and MCU.
The MCU must be configured to route outbound SIP calls
to DMA.
The H.323 Network Service of the MCU should register
it's dial prefix with the CMA gatekeeper.
When DMA is not used an Ad-hoc Entry Queue,
designated as Transit Entry Queue, must be pre-defined
on the MCU.
MLA 3.0.3 Multipoint Layout Application
Required for managing multi-screen endpoint layouts for
Cisco CTS 3XXX, Polycom TPX, RPX or OTX systems.
CMA 5.5 Polycom Converged Management Application - Gatekeeper
The gatekeeper must route calls to MCU based on the
MCU prefix registration on the gatekeeper.
Endpoints Telephony, desktop and room systems.
H.323 endpoints must register to the CMA or IOS
gatekeeper.
Polycom SIP endpoints must register to DMA as SIP
Proxy when DMA is used.
H.323 endpoints must register to the CMA or IOS
gatekeeper.
Table I-1 Solution Architecture Components
Component Version Description