Filter
Top Products
Chapter 22-System Configuration Flags
Polycom, Inc. 22-33
REMOVE_H323_EPC_CAP_
TO_NON_POLYCOM_VEND
OR
Used to disable EPC protocol. Use of Polycom’s proprietary
protocol, High Profile, EPC, may result in interoperability
issues when used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_H323_HIGH_PRO
FILE_CAP_TO_NON_POLY
COM_VENDOR
Used to disable High Profile protocol. Use of Polycom’s
proprietary protocol, High Profile, may result in interoperability
issues when used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
REMOVE_H323_HIGH_QUA
LITY_AUDIO_CAP_TO_NON
_POLYCOM_VENDOR
Used to disable the following Audio Codecs:
• G231
• G7221C
• G7221
• G719
• Siren22
• Siren14
Possible values: YES / NO
Default: NO
REMOVE_H323_LPR_CAP_
TO_NON_POLYCOM_VEND
OR
Used to disable H.323 LPR protocol. Use of Polycom’s
proprietary protocol, H.323 LPR, may result in interoperability
issues when used with other vendors’ endpoints.
Possible values: YES / NO
Default: NO
RMX_MANAGEMENT_SEC
URITY_PROTOCOL
Enter the protocol to be used for secure communications.
Default: TLSV1_SSLV3 (both).
Default for U.S. Federal licenses: TLSV1.
RTCP_FIR_ENABLE When set to YES, the Full Intra Request (FIR) is sent as INFO
(and not RTCP).
Default = YES
RTCP_FLOW_CONTROL_T
MMBR_ENABLE
Enables/disables the SIP RTCP flow control parameter.
Default: YES
RTCP_FLOW_CONTROL_T
MMBR_INTERVAL
Modifies the interval (in seconds) of the TMMBR (Temporary
Maximum Media Stream Bit Rate) parameter for SIP RTCP
flow control.
Range: 5 - 999 (seconds)
Default: 180
RTCP_PLI_ENABLE When set to YES, the (Picture Loss Indication (PLI) is sent as
INFO (and not RTCP).
Default = YES
Table 22-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description