Filter
Top Products
Chapter 16-Network Services
Polycom, Inc. 16-11
Modifying the Default IP Network Service
The Default IP Service parameters need to be modified if you want to change the:
• Network type that the RMX connects to
• IP address of the RMX Signaling Host
• IP addresses of the RMX Media boards
• Subnet mask of the RMX’s IP cards
• Gatekeeper parameters or add gatekeepers to the Alternate Gatekeepers list
• SIP server parameters
Fast Configuration Wizard
The Fast Configuration Wizard enables you to configure the Default IP Service. It starts
automatically if no Default IP Network Service is defined. This happens during First Time
Power-up, before the service has been defined or if the Default IP Service has been deleted,
followed by an RMX restart.
The IP Management Service tab in the Fast Configuration Wizard is enabled only if the factory
default Management IP addresses were not modified.
If the Fast Configuration Wizard does not start automatically, the Default IP Service must be
modified through the IP Network Properties dialog boxes.
To view or modify the Default IP Service:
1 In the RMX Management pane, click IP Network Services ().
2 In the Network list pane, double-click the Default IP Service ( , , or ) entry.
The Default IP Service - Networking IP dialog box opens.
RealPresence
RealPresence