Polycom RealPresence Collaboration Server (RMX) 1500/2000/4000 Administrator’s Guide
I-16 Polycom, Inc.
The following procedures 1 - 16 are a summary of the configuration procedures.
The detailed procedures 1 - 16 begin with "Procedure 1: Set the
MIN_TIP_COMPATIBILITY_LINE_RATE System Flag” on page I-17.
MCU
1
Set the
MIN_TIP_COMPATIBILITY_LINE_RATE
System Flag
2 Configuring the MCU to statically route outbound SIP calls to DMA or CUCM
3 Configuring the MCU’s H.323 Network Service to register with CMA gatekeeper
4 Configuring a TIP enabled Profile on the MCU
5 Configuring an Ad Hoc Entry Queue on the MCU if DMA is not used
6 Configuring a Meeting Room on the MCU
7 Configuring Participant Properties for dial out calls
DMA
If DMA is present in the configuration perform procedures 8 and 9, otherwise skip to
procedure 10.
8 Configuring DMA to route SIP calls to CUCM
9 Configuring a Virtual Meeting Room (VMR)
The procedures for configuring DMA are described in detail in the Polycom Unified
Communications Deployment Guide for Cisco Environments.
CMA
10 Configuring CMA to route H.323 calls to MCU
11 Configuring CMA for use with Cisco IOS Gatekeeper (Neighbored)
Immersive Telepresence Systems:
• RPX 200 and 400 systems
• OTX 300 system
• TPX HD 306 system
• ATX HD 300 system
V3.0.3
Requires TIP option key.
Requires Polycom Touch Control.
HDX Systems:
• 7000 HD Rev C
• 8000 HD Rev B
• 9006
• 4500
V3.0.3
Requires TIP option key.
The following Polycom peripheral:
• Polycom Touch Control
1.3.0
SIP ONLY (no TIP support) Version(s)
Spectralink wireless phones 8020/8030
Polycom VVX 1500 V4.0
Polycom VVX 1500 C V3.3.1
KIRK Wireless Server 300/600v3/6000
Table I-5 Supported current Polycom products