Polycom RMX 1500 Stereo Receiver User Manual


  Open as PDF
of 1010
 
Polycom RealPresence Collaboration Server (RMX) 1500/2000/4000
22-36 Polycom, Inc.
SET_DTMF_SOURCE_DIFF
_IN_SEC
If the ACCEPT_VOIP_DTMF_TYPE flag is set to 0 (Auto) this
flag determines the interval, in seconds after which the RMX
will accept both DTMF tones (inband) and digits (outband).
Default: 120
SIP_BFCP_DIAL_OUT_MOD
E
Controls BFCP’s use of UDP and TCP protocols for dial-out
SIP Client connections according to its value:
AUTO (Default)
If SIP Client supports UDP, TCP or UDP and TCP:
- BFCP/UDP is selected as Content sharing protocol.
UDP
If SIP Client supports UDP or UDP and TCP:
- BFCP/UDP selected as Content sharing protocol.
If SIP Client supports TCP
- Cannot share Content.
TCP
If SIP Client supports TCP or UDP and TCP
- BFCP/TCP selected as Content sharing protocol.
If SIP Client supports UDP
- Cannot share Content.
SIP_DUAL_DIRECTION_TC
P_CON
In environments set to integration with Microsoft, if set to YES
the system sends a new request on the same TCP connection
(instead of opening a new one).
SIP_ENABLE_FECC By default, FECC support for SIP endpoints is enabled at the
MCU level. You can disable it by manually adding this flag and
setting it to NO.
SIP_FAST_UPDATE_INTER
VAL_ENV
Default setting is 0 to prevent the RMX from automatically
sending an Intra request to all SIP endpoints.
Enter n (where n is any number of seconds other than 0) to let
the RMX automatically send an Intra request to all SIP
endpoints every n seconds.
It is recommended to set the flag to 0 and modify the
frequency in which the request is sent at the endpoint level
(as defined in the next flag).
SIP_FAST_UPDATE_INTER
VAL_EP
Default setting is 6 to let the RMX automatically send an Intra
request to Microsoft OC endpoints only, every 6 seconds.
Enter any other number of seconds to change the frequency
in which the RMX send the Intra request to Microsoft OC
endpoints only.
Enter 0 to disable this behavior at the endpoint level (not
recommended).
Table 22-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description