Filter
Top Products
Chapter 5-Cascading Conferences
Polycom, Inc. 5-7
• When a participant joins a conference with active Content, content cannot be viewed by
the new participant. Restart the Content.
• Cascaded MCUs/Gateways must be registered with the same Gatekeeper or
neighboring Gatekeepers. MCUs and endpoints must also be registered with
Gatekeepers.
• Gateway/MCU calls require definition of IVR Services. For more information see
"Defining the IVR Service for Gateway Calls” on page 19-14.
Gateway to Gateway Calls via ISDN Cascading Link
When H.323 participants connects to another IP participants via a Gateway to Gateway call
over an ISDN link, the dialing string includes the following components:
[GW A prefix in GK] - the prefix with which the RMX (gateway) is registered to the
gatekeeper.
[GW Profile ID] - The ID of the Gateway Profile defined on Gateway A to be used for
routing the call to the Gateway B.
[GW Profile ISDN/PSTN number] - the dial-in number assigned to the Gateway Profile
defined on Gateway B, including the required country and area codes.
Information required that is not part of the dialing string:
[Destination number] - the destination number as alias, IPv4 address or ISDN/PSTN
number of participant B.
The dialing string format:
H.323 Participants connecting to another IP participant via a Gateway to Gateway call over an
ISDN link enter a dial string using the format:
<GW A Prefix in GK><Gateway Profile_ID on GW A>*<Destination ISDN
Dial-in number assigned to the Gateway Session Profile GW
B>*<Destination Number, participant>
For example:
GW A prefix in Gatekeeper - (not used with SIP) 22
Gateway Profile ID in GW A 9999
ISDN Dial-in Number assigned to the
Gateway Session Profile GW B 4444103
IP Participant Alias 3456
H.323 participant dials: 229999*4444103 and when prompted for the Destination number
enters 3456 followed by the pound key (#) using DTMF codes.
SIP Participants connecting to another IP participant via a Gateway to Gateway call over an
ISDN link enter a dial string using the format:
<Gateway Profile_ID on GW A>@<Central Signaling IP GW
A>*<Destination ISDN Dial-in number assigned to the Gateway Session
Profile GW B>*<Destination Number, participant>
In version 7.1, H.239 content protocol is H.263 when sent over ISDN or H.323 Cascading link.