Filter
Top Products
Chapter 2-Conference Profiles
Polycom, Inc. 2-21
4 Click the Advanced tab.
Video Switching If the Operator Conference option is selected, this option is disabled,
and the selection is cleared.
Select the video protocol and resolution for the conference.
When selected, the conference is in a special conferencing mode
which implies that all participants must connect at the same line rate
and use the same video resolution. Participants with endpoints that
do not support the selected line rate and resolution will connect as
secondary (audio only).
For more information, see "Video Switching (VSW) Conferencing” on
page 2-4.
Notes:
• Video Switching conferencing mode is unavailable to ISDN
participants.
• To connect to a Video Switching conference via Entry Queue, the
Profile assigned to the Entry Queue must be set to Video
Switching. It is recommended to use the same profile for both the
destination conference and Entry Queue.
• Telepresence Mode is unavailable in Video Switching
conferences.
H.264 High Profile Select this check box to enable the use of H.264 High Profile in Video
Switching conferences. For more information, see "H.264 High Profile
Support in Video Switching Conferences” on page 2-53.
Operator Conference
(CP Only)
Select this option to define the profile of an Operator conference.
An Operator conference can only be a Continuous Presence
conference, therefore when selected, the Video Switching option is
disabled and cleared.
When defining an Operator Conference, the Send Content to Legacy
Endpoints option in the Video Settings tab is cleared and disabled.
For more information, see Chapter 10, “Operator Assistance &
Participant Move” on page 10-1.
Table 2-8 New AVC Profile - General Parameters (Continued)
Field/Option Description