Filter
Top Products
Polycom RealPresence Collaboration Server (RMX) 1500/2000/4000 Administrator’s Guide
16-46 Polycom, Inc.
11 Click OK.
The new range is added to the Dial-in Phone Numbers table.
12 Optional. Repeat steps 8 to 10 to define additional dial-in ranges.
13 Enter the MCU CLI (Calling Line Identification).
In a dial-in connections, the MCU CLI indicates the MCU’s number dialed by the
participant. In a dial-out connection, indicates the MCU (CLI) number as seen by the
participant
14 Click Save & Continue.
After clicking Save & Continue, you cannot use the Back button to return to previous
configuration dialog boxes.
The ISDN/PSTN Network Service is created and confirmed.
15 Click OK to continue the configuration.
The Spans dialog box opens displaying the following read-only fields:
— ID – The connector on the ISDN/PSTN card (PRI1 - PRI12).
— Slot – The media card that the ISDN/PSTN card is connected to (1 or 2)
— Service – The Network Service to which the span is assigned, or blank if the span is
not assigned to a Network Service
— Clock Source – Indicates whether the span acts as a clock source, and if it does,
whether it acts as a Primary or Backup clock source. The first span to synchronize
becomes the primary clock source.
— State – The type of alarm: No alarm, yellow alarm or red alarm.
• A range must include at least two dial-in numbers.
• A range cannot exceed 1000 numbers.