43
DYNAMIC ROUTE BACKUP
CONFIGURATION COMMANDS
n
Refer to “DCC Configuration Commands” on page 315 for more information
about dial control center (DCC).
standby routing-group
Syntax standby routing-group group-number
undo standby routing-group group-number
View Interface view
Parameter group-number: Dynamic route backup group number, ranging from 1 to 255.
Description Use the
standby routing-group command to enable the dynamic route backup
function on a dialup interface.
Use the
undo standby routing-group command to disable the dynamic route
backup function.
By default, the dynamic route backup function is disabled.
n
Before enabling the dynamic route backup function on a dialup interface, make
sure that DCC has been enabled on the dialup interface.
Example # Enable the dynamic route backup function on Bri 3/0.
<Sysname> system-view
[Sysname] interface bri 3/0
[Sysname-Bri3/0] standby routing-group 1
standby routing-rule
Syntax standby routing-rule group-number ip ip-address { mask | mask-length }
undo standby routing-rule group-number [ ip ip-address { mask | mask-length }]
View System view
Parameter group-number: Dynamic route backup group number, ranging from 1 to 255.
