2703
register-enable
Syntax register-enable { off | on }
undo register-enable
View SIP client view
Parameter off: Disables the SIP registration function.
on: Enables the SIP registration function.
Description Use the
register-enable on command to enable the SIP registration function.
Use the register-enable off command or the undo register-enable command
to disable the SIP registration function.
By default, the SIP registration function is disabled.
Example # Enable the SIP registration function.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] sip
[Sysname-voice-sip]sip-server master 169.54.5.10
[Sysname-voice-sip] register-enable on
registrar ipv4
Syntax registrar ipv4 ip-address [ port port-number ] [ expires seconds ] [ slave ]
undo registrar ipv4 [ slave ]
View SIP client view
Parameter ip-address: IP address of the registrar.
port port-number: Port number of the registrar, in the range of 1 to 65535. The
default port number is 5060.
expires seconds: Aging time for registration in seconds, in the range of 60 to
65,535. The default aging time is 3,600.
slave: Specifies the registrar as a slave server.
Description Use the registrar ipv4 command to configure registrar information on the SIP
UA.
Use the
undo registrar ipv4 command to remove the registrar information from
the SIP UA.
