1130 CHAPTER 76: OSPF CONFIGURATION COMMANDS
enable link-local-signaling
Syntax enable link-local-signaling
undo enable link-local-signaling
View OSPF view
Parameters None
Description Use the
enable link-local-signaling command to enable the OSPF link-local
signaling (LLC) capability.
Use the
undo enable link-local-signaling command to disable the OSPF
link-local signaling capability.
By default, this capability is disabled.
Examples # Enable link-local signaling for OSPF process 1.
<Sysname> system-view
[Sysname] ospf 1
[Sysname-ospf-1] enable link-local-signaling
enable log
Syntax enable log [ config | error | state ]
undo enable log [ config | error | state ]
View OSPF view
Parameters config: Enables configuration logging.
error: Enables error logging.
state: Enables state logging.
Description Use the
enable command to enable specified OSPF logging.
Cost Interface route cost
State Interface state
Type Type: virtual link
Transit Area Transit area ID if the interface attached to a virtual link
Timers Values of timers: Hello, Dead, Poll (NBMA), Retransmit, and
Interface transmit delay
Table 277 Description on the fields of the display ospf vlink command
Field Description
