Filter
Top Products
86
Creating a song (Song Recording)
you actually struck the pad to be input as the velocity data, set this to “Real.” If you
want to input a fixed velocity value, set this as desired; as a guideline, p (piano) = 60,
mf (mezzo-forte) = 90, and f (forte) = 120.
6.
Strike .
When you strike a pad, data will be input and length
specified by the Step Time will forward. The input
data as a bar (length specified by the duration) and as
a bar graph (velocity).
During step recording, you can temporarily pause step
recording by pressing [REC] to make the indicator blink
(“rehearsal mode”). In this state, striking the pads will not cause data to be recorded. This is
useful when you want to check the sounds you are using, or when you want to practice.
Using the F-buttons for input
7.
Repeat steps 5~6 to continue inputting notes.
8.
When you're finished step recording, press .
The [REC] indicator will go dark.
Inputting chords
You can input a chord by pressing two or more pad simultaneously. The cursor will
advance to the next step when you release the pads.
If you're not satisfied with the recorded result
If you're not satisfied with the results of the step recording you just performed, you can
press UNDO/REDO to return to the state prior to recording. Refer to
Undoing a
recording or editing operation (Undo)
(p. 80).
The (-) direction will widen (zoom-out) the displayed area. This lets you see all of the
input data at a glance.
F-button
Operation
(Back Step)
Cancels the previously-input note or rest.
(Tie)
Extends the previously-input note by the length of the
Step Time.
(Rest)
Inputs a rest of the length of the Step Time.
Velocity
Inputed data
You can use CURSOR
(up/down) to move the
displayed area up or down.
You can use [SHIFT] +
CURSOR to zoom-in or
zoom-out the input data
display. The (+) direction will
narrow (zoom-in) the
displayed area. It's convenient
to zoom-in on a specific area if
you've input numerous
closely-spaced notes.
Each parameter will maintain
the value that was most
recently input. If you want the
next note to have the same
settings, there's no need to
change them. In other words,
once you've set the Duration
and Velocity parameters, you
can usually leave them
unchanged, and simply use the
Step Time parameter and the
note pitch (pad) to continue
inputting notes.
ECS05_manual_e.book 86 ページ ２００５年１１月３０日 水曜日 午前１１時１４分