Filter
Top Products
336
DISK/USB
USB screen
This switches the MV-8000 to USB-connection mode,
which lets you transfer data between the internal
hard disk and your computer.
To access this screen
•
➜
You must connect or disconnect the USB cable while
the MV-8000 is powered-off. Never connect or
disconnect the USB cable or turn the power off
while you are in USB mode. Doing so may damage
data or cause malfunctions.
Explanation of each area
1.
Communication status
Graphically indicates the connection status between
the MV-8000 and your computer.
The MV-8000 can communicate via USB with
Windows Me/2000/XP or later, Mac OS 9.0.4 or
later, and Mac OS X 10.2 or later. Also, depending
on the type of computer you are using, this may not
work correctly even if your computer uses one of
the above operating systems.
If the display asks “Save Current?”
Your changes will be lost unless you save the current
project before switching to USB mode.
If you don't save the current project at the “Save
Current?” prompt, there is no way for you to
recover that data (unless you have previously made
a backup of it). Roland accepts no responsibility for
the recovery of lost data, nor for any damages that
may result from such loss.
F-buttons
Connect / Disconnect
If the MV-8000 is not communicating with your
computer, this will indicate Connect; press
[F5 (Connect)] to initiate the connection. If the
MV-8000 is already communicating with your
computer, this will indicate Disconnect; press
[F5 (Disconnect)] to stop communication.
Before you stop communication
Windows Me/2000/XP
Use the Safely Remove Hardware icon in your
taskbar to break the connection with the MV-8000,
and then press [F5 (Disconnect)] on the MV-8000.
Macintosh
Drag the MV-8000 drive icon on your desktop into
the trash, and then press [F5 (Disconnect)] on the
MV-8000.
For details on terminating the connection with your
Windows or Macintosh computer, read
To stop
communication with your computer
(p. 153).
Status
Explanation
Disconnected
Connected
F-button
Explanation
No
To switch to USB mode without sav-
ing your changes.
Yes
To save before switching to USB
mode.
To cancel without switching to USB
mode.
ECS05_manual_e.book 336 ページ ２００５年１１月３０日 水曜日 午前１１時１４分