Filter
Top Products
355
SAMPLING
PROJECT SYSTEM DISK/USB MASTERING SAMPLING
SAMPLING / RE-SAMPLING screen
Here you can perform sampling.
To access this screen
•
➜
(for audio phrase sampling)
•
➜
(for patch sampling)
•
➜
(for sampling)
The SAMPLING screen that appears is the same for
any type of sampling. The type of sampling is
shown in the title area.
Explanation of each area
1.
SAMPLING
Indicates the type of sampling.
2.
Level meter
Indicates the level of the audio input signal. When
sampling, adjust this level so that the meter moves in
the region of -12~0 dB.
The sound will distort if the display reaches 0 dB
(clip indicator lit).
3.
Sample Type
Specifies the number of channels that will be
sampled.
4.
Routing
Indicates the sampled source and the effects that will
be used.
• If the MV8-OP1 (sold separately) is not installed,
this will be fixed at Analog (the COAXIAL,
OPTICAL, and R-BUS icons are not displayed).
• Use the SYSTEM
GLOBAL screen
(p. 320) to
switch the input source.
• To Re-Sampling, press [F2 (Re-Sampling)].
5.
Start Trigger
Specifies how sampling will begin.
6.
Level
Specifies the response level when using the input
level to start sampling.
Range: 1~
6
The Level setting is used only when Start Trigger =
Level.
7.
Stop Trigger
Specifies how sampling will stop.
Display
Explanation
AUDIO PHRASE
Audio phrase sampling
PATCH Patch sampling
SAMPLING
Sample and save in the
sample folder
Value
Explanation
Mono
Monaural (one channel)
Stereo
Stereo (two channels)
Input display
area
Explanation
ANALOG
Analog input (MIC/LINE or
PHONO)
COAXIAL Digital input (coaxial)
OPTICAL Digital input (optical)
R-BUS Digital input (R-BUS)
MIX BUS when Re-Sampling
Value
Explanation
Manual
Sampling will be started manually.
Level
Sampling will be triggered by the
input level.
Pad
Sampling will begin when you strike
a pad.
Play
Sampling will begin when you play
back the sequencer.
Value Explanation
Manual
Sampling will be stopped manually.
Beat
Sampling will stop after the number
of beats specified by the Length pa-
rameter.
Time
Sampling will stop after the time
specified by the Length parameter.
ECS05_manual_e.book 355 ページ ２００５年１１月３０日 水曜日 午前１１時１４分