Filter
Top Products
214
SEQUENCE
RECORDING PARAMETER (AUDIO) popup
Here you can set recording parameters for an audio
track.
To access this screen
•
➜
•
➜
In order to open this popup, you must specify an
audio track as the current track.
Explanation of each area
1.
Rec Mode (Recording mode)
Specifies how recording will occur.
2.
Count In
Specifies how recording will start.
3.
Auto Punch In / Auto Punch Out
You can specify two time locations at which
recording will automatically start and stop (“auto
punch”).
You cannot set Auto Punch In to a location after
Auto Punch Out.
4.
Metronome Mode
Specifies when the metronome signal will be output.
5.
Input Quantize Type
You can apply quantization while you record into the
sequencer when Rec Mode is “Event.”
Range: (60), (80),
(120)
, (160), (240),
(320), (480)
6.
Level meter
Indicates the input level.
F-buttons
Reset Peak
Clears the indicators of the peak hold in the Level
meters.
Metronome
Displays the
METRONOME popup
(p. 215).
Close
Closes the
RECORDING PARAMETER (AUDIO)
popup
(p. 214).
Value
Explanation
Direct
Stereo
Record audio directly from the Input to the
track (2-channels).
Direct
Mono
Record audio directly from the Input to the
track (1-channel).
Event
Record the playback timing of audio phrases
triggered from the velocity pads.
Since only timing data will be recorded,
this is a way to conserve the data size
when recording the identical audio
material on the track.
Value
Explanation
Off
Recording will begin the instant you press
[PLAY]. (There will be no count.)
1 Meas
Recording will begin after a one-measure
count.
2 Meas
Recording will begin after a two-measure
count.
Parameter
Value
Auto Punch In
0000-01-000
~ (Auto Punch
Out time)
Auto Punch Out
(
Auto Punch In time
) ~
9999-**-***
Value
Explanation
Off
The metronome will not sound.
Rec Only
The metronome will sound only during
recording.
Play&Rec
The metronome will sound during play-
back and recording.
Always The metronome will always sound.
ECS05_manual_e.book 214 ページ ２００５年１１月３０日 水曜日 午前１１時１４分