Filter
Top Products
342
MASTERING
MASTERING screen
Here you can use the mastering tool kit to master an
audio file.
To access this screen
•
➜➜
(select a file)
➜
Explanation of each area
1.
Mastering Tool Kit
Makes settings for the mastering effects.
In this screen you can set the Compressor
parameters of the mastering tool kit. To set the other
parameters of the mastering tool kit (e.g., the
Expander and Equalizer parameters), use the
MASTERING TOOL KIT EDIT screen
(p. 345).
2.
Mastering status
Indicates whether the mastering toolkit is off or on.
Use [F3 (MTK On/Off)] to switch this.
3.
Frequency band division
The mastering tool kit's Compressor lets you process
the high, mid, and low-frequency regions separately.
4.
Attack
This is the Attack Time parameter of the compressor.
It specifies the time from when the volume exceeds
the value of the Threshold parameter until
compression begins.
Range: 0~100 ms
You can use the C1 knob to adjust this.
5.
Release
This is the Release Time parameter of the compressor.
It specifies the time from when the volume falls
below the value of the Threshold parameter until
compression is not longer applied.
Range: 50~5000 ms
You can use the C2 knob to adjust this.
6.
Level
Specifies the output level of the compressor.
Range: -80~+6 dB
You can use the C3 knob to adjust this.
7.
Threshold
Specifies the volume at which the compressor will
begin to apply.
Range: -24~0 dB
8.
Ratio
Specifies the compression ratio (source signal:output
signal) applied by the compressor. This is the
proportion by which the output will be reduced
when the input level exceeds the value of the
Threshold parameter.
Range: 1:1.00~1:16.0, 1:INF
9.
GR (Gain Reduction meter)
Indicates the amount by which the compressor is
compressing the level.
Band
Explanation
High
Parameters for the high-frequency band
compressor
Mid
Parameters for the mid-frequency band
compressor
Low
Parameters for the low-frequency band
compressor
ECS05_manual_e.book 342 ページ ２００５年１１月３０日 水曜日 午前１１時１４分