325
SYSTEM
PROJECT SYSTEM DISK/USB MASTERING SAMPLING
V-LINK screen
Here you can make settings for using V-LINK to
perform music and video together.
To access this screen
•
➜
(move the cursor to the upper row of
icons)
➜
Explanation of each area
1.
Control Ch (Control Channel)
Specifies the MIDI connector and channel used to
control the video clips, color Cb/Cr, brightness, and
video effect switching on a connected V-LINK device.
Range: A-1~A-16, B-1~
B-16
, R-1~R-16
R-1~R-16 are MIDI channels transmitted from
R-BUS. In order to use this setting, the MV8-OP1
(sold separately) and DIF-AT24 (sold separately)
must be installed.
2.
Color Cr Control
Specifies the control change number used to control
the hue of the color difference signal Cr (red).
Range: Off, CC1, CC5, CC7, CC10, CC11,
CC71
, CC72, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
3.
Color Cb Control
Specifies the control change number used to control
the hue of the color difference signal Cb (blue).
Range: Off,
CC1
, CC5, CC7, CC10, CC11,
CC71, CC72, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
4.
Brightness Control
Specifies the control change number used to control
the brightness of the image.
Range: Off, CC1, CC5, CC7, CC10, CC11,
CC71, CC72, CC73,
CC74
, CC91,
CC92, CC93, Channel Aftertouch
5.
Dissolve Time
Specifies the control change number used to control
the switching time between clip images.
Range: Off, CC1, CC5, CC7, CC10, CC11,
CC71, CC72,
CC73
, CC74, CC91,
CC92, CC93, Channel Aftertouch
6.
VFX Control (Video Effect Control)
Specifies the control change number used to control
video effects.
Range: Off, CC1, CC5, CC7, CC10, CC11,
CC71,
CC72
, CC73, CC74, CC91,
CC92, CC93, Channel Aftertouch
7.
Local Switch
Specifies whether the MV-8000's internal sound
source will respond to the pads.
Value
Explanation
Off
Striking the pads will not play the inter-
nal sounds. You cannot sequence
recording if turn this parameter off.
On
Striking the pads will play the internal
sounds.
ECS05_manual_e.book 325 ページ 2005年11月30日 水曜日 午前11時14分