Filter
Top Products
295
INSTRUMENTS
Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES
8.
Envelope Velo Sens T1 (A) (Envelope Velocity
Sensitivity Attack Time)
Specifies how velocity will affect T1 of the amplifier
envelope (see the Amplifier Envelope diagram). Use
positive (+) settings if you want T1 to be faster for
stronger velocities, or negative (-) settings if you want
it to be slower.
Range: -63~
0
~+63
9.
Envelope Velo Sens T4 (R) (Envelope Velocity
Sensitivity Release Time)
Specifies how velocity will affect T4 of the amplifier
envelope (see the Amplifier Envelope diagram). Use
positive (+) settings if you want T4 to be faster for
higher note-off velocities (i.e., releasing the key more
quickly), or negative (-) settings if you want it to be
slower.
Range: -63~
0
~+63
10.
Envelope T1 (A), T2 , T3(D), T4 (R) (Envelope Times
1~4)
These specify the amplifier envelope times (T1~T4).
Higher values lengthen the time until the next level is
reached (e.g., T2 sets the time of the change from L1
to L2).
Range:
0
~127
11.
Envelope L1, L2, L3 (S) (Envelope Levels 1~3)
These specify the amplifier envelope levels (L1~L3).
Each parameter specifies the change in level relative
to the setting of the Level parameter in the
PARTIAL
EDIT (SMT) screen
(p. 289).
Range:
0
~127
F-buttons
Sample Edit
Displays the
SAMPLE EDIT screen
(p. 279).
SMT (Sample Mix Table)
Displays the
PARTIAL EDIT (SMT) screen
(p. 289).
Filter
Displays the
PARTIAL EDIT (FILTER) screen
(p.
291).
LFO (Low Frequency Oscillator)
Displays the
PARTIAL EDIT (LFO) screen
(p. 296).
T1 T2 T3 T4
L3
L1
L2
Key-off
Volume
Time
Key-on
T: Time, L: Level
Amplifier envelope
ECS05_manual_e.book 295 ページ ２００５年１１月３０日 水曜日 午前１１時１４分