Filter
Top Products
80
Creating a song (Song Recording)
Undoing a recording or editing operation (Undo)
If you're not satisfied with the results of the realtime-recording or editing operation
you just performed, you can press to return to the previous state (Undo). If the
Undo function is available after recording or editing a sequence, [UNDO] will light
orange. If you press [UNDO] to return to the previous state and [UNDO] will blink.
Canceling an Undo operation (Redo)
After executing Undo, you can perform Redo to return to the state prior to executing
Undo.
Pressing (blink) after you've executed Undo will execute the Redo function.
[UNDO] will return to lit.
Recording while looping (Loop Recording)
Here's a quick way to start loop recording from the current measure.
1.
Move to the time location at which you want to start loop recording.
2.
Press .
The loop parameters will be set automatically, and LOOP [ON] will light orange. Now
you can perform loop recording from the beginning of the current measure.
3.
Start recording as described in
Basic procedure for realtime recording
(p.
78).
If you want to specify the loop region manually, access the SEQUENCE screen, press [MENU],
and select Loop to display the
LOOP popup
(p. 240). In the LOOP PARAMETER popup, set the
Loop Top and Loop End to specify the loop region. This lets you specify the time location freely
(measure - beat - tick). However in this case, the length specified by Loop Quick Set Length will
be ignored.
In the
LOOP popup
(p. 240), you can press [F1 (Now
➔
Top)] to assign the current time as the
value of the Top parameter. Press [F2 (Now
➔
End)] will assign the current time as the value of
the End parameter.
Using auto-punch recording
Here's how you can pre-specify the time locations at which recording will begin
(punch-in) and end (punch-out).
1.
Press + .
The PUNCH IN/OUT popup window will appear.
2.
Set the Punch In and Punch Out parameters.
Set the Punch In parameter to the time location at
which you want recording to begin, and the Punch
Out parameter to the location at which you want
recording to end.
3.
Press .
The PUNCH IN/OUT popup window will close.
By default, the loop length will
be two measures. If you want
to change the length, access the
LOOP popup (in the
SEQUENCE screen, select
[MENU]
➔ Loop), and change
the Loop Quick Set Length
setting.
If you want to change the
location at which looping
b
egins, move the current time
to the desired loop-start
location and then press
[QUICK SET] once again.
ECS05_manual_e.book 80 ページ ２００５年１１月３０日 水曜日 午前１１時１４分