Filter
Top Products
48
Editing a sampled sound
Making instrument settings
Here's how to make basic settings for a part.
Accessing the Instrument screen
1.
Press .
The INSTRUMENTS screen will appear.
2.
Use (up/down) to select the part that uses the patch you want to play.
The selected part number (the current part) is highlighted.
To adjust the volume of the part
➜
adjust the Levl (Level) parameter.
To adjust the stereo position (pan) of the part
➜
adjust the Pan parameter.
To use effects (delay/chorus, reverb)
➜
adjust the Cho parameter or Rev parameter.
These parameters send the sound of the patch to the delay/chorus effect and the reverb
effect. Raise the DlyCho Send parameter to apply delay/chorus, or raise the Reverb
Send parameter to apply reverb. The sound that's processed through each effect will
be heard mixed with the original sound.
To change the output routing of the patch sound
You can specify how the sound of the patch will be sent from the sound generator
section through the various sections of the MV-8000 and finally output.
➜
set the Output (Output Assign) parameter.
To allocate a specific amount of polyphony
➜
set the VoRsv (Voice Reserve) parameter.
INSTRU-
MENTS
Adjusts
the volume.
Specifies
the mute setting.
Adjusts
the pan.
Specifies
the output routing
of the patch sound.
Sends the signal
to the delay/chorus effect.
Sends the signal
to the reverb effect.
Specifies what will happen
when the maximum polyphony
is exceeded.
For details on the
INSTRUMENTS screen (p.
265) and its parameters,
refer to INSTRUMENTS
screen (p. 265), MIDI
FILTER screen (p. 267).
Strike the pads to hear the
result of your settings. To
check the pads to which the
sounds are assigned, press the
[PAD BANKS] button to
display the PAD BANKS
popup (p. 202).
ECS05_manual_e.book 48 ページ ２００５年１１月３０日 水曜日 午前１１時１４分